Verifying And Saving Your Configuration; Where To Go Next - Cisco VG224 - Analog Phone Gateway Quick Start Manual
Voice gateway
Hide thumbs
Also See for VG224 - Analog Phone Gateway:
- Software manual (66 pages) ,
- Hardware installation manual (75 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
Command
Step 1
Router# configure terminal
Step 2
Router(config)# enable password password
Step 3
Router(config)# interface Fast Ethernet 0/0
Step 4
Router(config-if)# ip address IP-address subnet-mask
Step 5
Router(config-if)# no shutdown
Step 6
Router(config-if)# exit
Step 7
Router(config)# line vty 0 4
Step 8
Router(config-line)# password password
Step 9
Router(config-line)# end
Step 10
Router# copy system:running-config nvram:startup-config
Verifying and Saving Your Configuration
To verify the configuration and save it in NVRAM so that the configuration remains in effect if the Cisco VG224 is restarted,
enter the following commands:
Command
Router# show running-config
Router# show startup-config
Router# show voice port summary
Router# copy running-config startup-config
Where to Go Next
For additional specialized configuration procedures, refer to the appropriate Cisco IOS software configuration documentation.
See the "User Documentation" section on page 2 for help in locating these documents.
Tip
16
Description
Enters global configuration mode.
Sets a password for the privileged EXEC mode.
Enters interface configuration mode.
Enters the IP address and subnet mask for the Fast
Ethernet port.
Activates the Fast Ethernet port.
Returns to global configuration mode.
Enters line configuration mode.
Sets a password for remote access to the
Cisco VG224.
Returns to privileged EXEC mode.
Saves the configuration.
Description
Displays the current operating configuration, including any changes you
have just made.
Displays the configuration currently stored in NVRAM.
Displays the voice port parameter settings.
Writes the current running configuration to NVRAM, where it overwrites
the startup configuration and becomes the new startup configuration.
If you reboot the Cisco VG224 or turn off the power before you
Note
complete this step, you lose the configuration.
- Quick Links:
- Performing the Initial Configuration
Hide quick links:
Advertisement
Table of Contents
