Cisco CRS-1 - Carrier Routing System Router Migration Manual page 222
Carrier routing system
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
show controllers (Ethernet)
PCS Error'd Block Counts: 0
PCS BER Counts: 0
PCS has NO Block Lock
WIS: HW In LAN Mode - No Info
XFP General Info:
=================
UDI Checking: Disabled
PHY/XFP Status: XFP Not UDI Compliant
XFP is Working as expected
XFP Info:
=========
Max Power Dissipation: 2500 mW
XFP Type: 10GBASE-LR
Vendor Name: CISCO-SUMITOMO
Vendor Part Number: SXP3101NV-C1
Vendor OUI: 0x00-0x00-0x5f
Vendor Hardware Revision: C
Vendor Serial number: ECL120701L2
Date Code (yy/mm/dd): 08/02/27
Lot Code: D0
Cisco PID: XFP-10GLR-OC192SR
Cisco VID: V02
Cisco PN: 10-1989-02
ID: XFP
Extended ID: 0x58
TX ref clock input is not required
CDP is supported
Power Level 2 (2.5W max. power)
Minimum bit rate is 9900 MBits/s.
Maximum bit rate is 10300 MBits/s.
XFP Detail Info:
================
Temp: 32.223
Tx bias: 0.0 mA
Tx power: 0.0 mW (-40 dBm)
Rx power: 0.33 mW (-24 dBm)
AUX 1: +3.3V Supply Voltage: 0x70
AUX 2: Auxiliary monitoring not implemented: 0x0
XFP Status: enabled.
laser is enabled
MOD NR is not ready
is powered off
doesn't have interrupt(s)
has LOS
data is ready
TX path is ready
TX laser is not in fault condition
TX path CDR is locked
RX path is not ready
RX path CDR is not locked
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
3-62
Chapter 3
Cisco CRS-3 Carrier Routing System Router Command Changes
OL-13669-03
Advertisement
Chapters
Table of Contents
