Table of Contents
Advertisement
Appendix
6
Connect the pedal cord and the AC power
adaptor.
6-1 Insert the pedal cord plug to the pedal connector
from the rear.
6-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3 Use a vinyl tie to take up any slack in the pedal cord.
6-4 Insert the DC plug of the AC power adaptor into
the DC IN jack.
6-1
6-3
6-2
■ Connecting the pedal cord
Insert the pedal cord securely until the metal part of the
cord plug disappears from view. Otherwise, the pedal
may not function properly.
30
YDP-162/142 Owner's Manual
6-4
Insert the cord all the
way until the metal part
of the plug disappears
from view.
7
Set the adjuster.
Rotate the adjuster until it comes in firm contact with
the floor surface.
8
Attach the headphone hanger. (YDP-162 only)
Use the included two screws (4 x 10 mm) to attach the
hanger as shown in the illustration.
■ After completing the assembly, please
check the following.
• Are there any parts left over?
Review the assembly procedure and correct any
errors.
• Is this instrument clear of doors and other movable
fixtures?
Move the instrument to an appropriate location.
• Does this instrument make a rattling noise when you
shake it?
Tighten all screws.
• Does the pedal box rattle or give way when you step
on the pedals?
Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal and power cords inserted securely into
the sockets?
Check the connection.
• If the main unit creaks or is otherwise unsteady when
you play on the keyboard, refer to the assembly
diagrams and retighten all screws.
Hide quick links:
Advertisement
Table of Contents
