Table of Contents
Advertisement
Problem
6
Uneven seam
7
Large degree of puckering
(excess tension)
8
Material slippage
2949M
9
Lower thread is tangled at
the sewing start.
Lower
thread
Is the presser foot pressure too weak?
Adjust the presser foot pressure.
Is the feed dog too low?
Adjust the feed dog height.
Is the bobbin scratched?
If the bobbin is damaged, smooth it with an oiled grindstone or
replace it.
Is the V-belt tension too low?
Adjust so that there is 10-14 mm of deflection in the V-belt
when it is pushed with a finger.
2948M
Is the upper thread tension too strong?
Make the upper thread tension as weak as possible.
Is the lower thread tension too strong?
Make the lower thread tension as weak as possible.
Are the thread take-up spring tensions too strong?
Make the thread take-up spring tension as weak as possible.
Is the thread take-up spring operating range too large?
Move the stopper to as high a position as possible.
Is the presser foot pressure too strong?
Adjust the presser foot pressure.
Is the thread take-up amount too small?
Adjust the thread take-up amount.
2949M
Is the presser foot pressure too strong?
Adjust the presser foot pressure.
2950M
Is the bobbin spinning direction correct when the lower thread is
being pulled?
Set the bobbin so that it turns in the opposite direction to the
rotary hook.
Is there too much thread
wound onto the bobbin?
The
bobbin
amount should not be
more that 80 %.
Is the bobbin turning smoothly?
If the bobbin is not turning smoothly, replace the bobbin.
Is a bobbin other that the light-alloy bobbins specified by Brother
being used?
Use only bobbins which are specified by Brother.
2951M
T-8420B, 8450B, 8720B, 8750B
Possible cause
winding
10. TROUBLESHOOTING
Page
26
*
7
25
25
*
*
26
27
26
17-18
16
17-18
2124M
36
Hide quick links:
Advertisement
Table of Contents
