Threading The Upper Thread; Adjusting The Stitch Length - Brother S-7220B Instruction Manual
Single needle direct drive needle feed lock stitcher with thread trimmer
Hide thumbs
Also See for S-7220B:
- Manual de instrucciones (74 pages) ,
- Instruction manual (72 pages) ,
- Basic operation manual (28 pages)
Table of Contents
Advertisement
4. PREPARATION BEFORE SEWING
4-5. Threading the upper thread
Turn off the power switch before threading the upper thread.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
4-6. Adjusting the stitch length
15
CAUTION
3737M
Unlocked
Locked
3738M
S-7220B
Turn the machine pulley and raise the thread take-up (1)
before threading the upper thread.
This will make threading easier and it will prevent the thread
from coming out at the sewing start.
1. Push the dial lock lever (1) up until it clicks to release the
lock.
2. Turn the stitch length dial (2) clockwise or counter-
clockwise so that the desired stitch length is at the upper-
most position on the dial.
The larger the number, the longer the stitch length will
be.
(The numbers on the dial are for use as a guide. The
length of the finished stitches may vary depending on
the type and thickness of material being sewn. Adjust
while looking at the finished stitches.)
When turning the stitch length dial (2) from a larger
setting to a smaller setting, it will be easier to turn the
dial if the reverse lever (3) is pushed to the halfway-
down position.
3. Push the dial lock lever (1) down firmly to lock it.
* Check that the stitch length dial (2) does not rotate.
Hide quick links:
Advertisement
Table of Contents
