Lubrication - Brother S-7220B Instruction Manual
Single needle direct drive needle feed lock stitcher with thread trimmer
Hide thumbs
Also See for S-7220B:
- Manual de instrucciones (74 pages) ,
- Instruction manual (72 pages) ,
- Basic operation manual (28 pages)
Table of Contents
Advertisement
3-3. Lubrication
Do not connect the power cord until lubrication has been completed, otherwise the machine may operate if the
treadle is depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get
into your eyes or onto your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and
diarrhea.
Keep the oil out of the reach of children.
When cutting the nozzle of the oil tank, hold the base of the nozzle securely.
If you hold the end of the nozzle, injury from the scissors may result.
CAUTION
3640M
1. Hold the base of the nozzle on the accessory oil tank (1),
2. Tilt back the machine head.
3. Remove the rubber cap (2), and pour 120ml of lubricating
4. Replace the rubber cap (1).
5. Return the machine head to its original position.
6. Check that the oil gauge (6) comes to the upper reference
<Lubrication oil replenishment interval>
If the oil gauge (6) drops below the lower reference line (or if
the oil level drops below the lower reference line (7) on the oil
tank (3)), be sure to replenish the oil.
Upper reference
line
Lower reference
line
3728M
S-7220B
The sewing machine should always be lubricated and the
oil supply replenished before it is used for the first time,
and also after long periods of non-use.
Use only the lubricating oil (Nisseki Mitsubishi Sewing
Lube 10N; VG10) specified by Brother.
* If this type of lubricating oil is difficult to obtain, the
recommended oil to use is <Exxon Mobil Essotex SM10;
VG10>.
and then use scissors to cut 3 - 5 mm off the end of the
nozzle.
oil into the oil tank (3).
(Use the upper reference line (4) as a guide when
pouring.)
line in the oil gauge window (5).
3. INSTALLATION
8
Hide quick links:
Advertisement
Table of Contents
