Installing A Drive - IBM NetVista Hardware Maintenance Manual
Hardware maintenance manual for netvista 2289 and 6824 systems
Hide thumbs
Also See for NetVista:
- Hardware maintenance manual (211 pages) ,
- Hardware manual (135 pages) ,
- Guide utilisateur (124 pages)
Table of Contents
Advertisement
v A 3.5-inch diskette disk drive in bay 3
v A 3.5-inch hard drive in bay 4
Any bay that does not have a drive installed has a static shield and bay panel
installed.
The following illustration shows the locations of the drive bays.
The following table describes some of the drives you can install in each bay and
their height requirements.
1 Bay 1 - Maximum height: 43.0 mm (1.7 in.)
2 Bay 2 - Maximum height: 43.0 mm (1.7 in.)
3 Bay 3 - Maximum height: 25.8 mm (1.0 in.)
4 Bay 4 - Maximum height: 25.8 mm (1.0 in.)
Notes:
1. Drives that are greater than 43.0 mm (1.7 in.) high cannot be installed.
2. Install removable media (tape or CD) drives in the accessible bays (bay 1 or 2).
Installing a drive
To install an internal drive, follow these steps:
1. Remove the cover. See "Removing the cover" on page 23.
2. If your computer has a CD-ROM drive or DVD-ROM drive, you might need to
remove the signal and power cables from the drive.
3. Remove the bay panel from the drive bay by inserting a flat-blade screwdriver
at the end and gently prying it loose.
CD-ROM drive or DVD-ROM drive
(preinstalled in some models)
5.25-inch hard disk drive
5.25-inch hard disk drive
3.5-inch hard disk drive (requires a
mounting bracket)
CD-ROM drive
DVD-ROM drive
3.5-inch diskette drive (preinstalled)
3.5-inch hard disk drive
Chapter 5. Installing Options
29
Hide quick links:
Advertisement
Table of Contents
