Brother BAS-342G PS Instruction Manual page 77

Direct drive programmable electronic pattern sewer, "perfect stitch"

Hide thumbs Also See for BAS-342G PS:

Service manual (153 pages)

Manual de instrucciones (86 pages)

Instruction manual (84 pages)

Table Of Contents

Table of Contents

Code

Sewing machine motor stopped due to a problem, or synchronizer is faulty.

E130

Turn off the power, and then turn the machine pulley and check if the sewing machine has locked up.

Check that connectors P4 and P5 on the power supply motor P.C. board are properly connected.

Synchronizer is faulty.

E131

Turn off the power, and then check that connector P5 on the power supply motor P. C. board is properly

connected.

Problem detected with sewing machine motor operation.

E132

Turn off the power, and then check that connector P4 on the power supply motor P.C. board is properly

connected.

Sewing machine motor stopping position is incorrect.

E133

Turn off the power, and then check that connector P5 on the power supply motor P.C. board is properly

connected.

Sewing machine motor is overheating, or temperature sensor is faulty.

Turn off the power, and then check the sewing machine motor.

E150

(When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle

operation), the upper shaft motor may overheat and the "E150" error code may be generated.)

Feed mechanism-related errors

Code

X-feed motor home position cannot be detected.

Problem with X -feed motor or poor X home position sensor connection.

E200

Turn off the power, and then check that connector P10 on the PMD P.C. board and connector P20 on the main

P.C. board are properly connected.

X-feed motor stopped due to a problem.

E201

Turn off the power, and then check if there are any problems in the X-feed direction.

Problem with X-feed motor or Y-feed motor home position adjustment data.

E202

Re-adjust the home position.

X feed motor stopped abnormally during sewing.

E204

Turn off the power, and then check if there are any problems in the X-feed direction.

X feed motor stopped abnormally while moving to the sewing start position.

E205

Turn off the power, and then check if there are any problems in the X-feed direction.

X feed motor stopped abnormally during test feeding.

E206

Turn off the power, and then check if there are any problems in the X-feed direction.

X feed motor stopped abnormally during programming.

E207

Turn off the power, and then check if there are any problems in the X-feed direction.

Y-feed motor home position cannot be detected.

Problem with Y-feed motor or poor Y home position sensor connection.

E210

Turn off the power, and then check that connector P8 on the PMD P.C. board and connector P4 on the main P.C.

board are properly connected.

Y-feed motor stopped due to a problem.

E211