Presser Foot Installation Position; Changing The Intermittent Stroke - Brother BAS-342G PS Instruction Manual

Direct drive programmable electronic pattern sewer, "perfect stitch"

Hide thumbs Also See for BAS-342G PS:

Table of Contents

11-12. Presser foot installation position

The intermittent stroke can be adjusted to within 2 − 10 mm by adjusting the position of the stepping clamp connecting rod

and changing the installation position of stepping clamp link A.

1. Remove the face plate.

2. Remove the two screws (1) and the two shoulder screws (2), and then remove stepping clamp link A (3).

3. Change the installation position for stepping clamp link A (3) to either A, B or C above.

If the position of the stepping clamp connecting rod is adjusted as described in the following at any one of the installation

positions, the adjustment range for the intermittent stroke will as given in the following table. (Refer to the next page.)

Installation position

1894B

2 − 4.5mm

4.5 − 10mm

0 mm (Presser foot does not move up and down)

BAS-342G PS

Install the intermittent presser foot (1) with the screw (2) so

that the distance from the bottom of the intermittent presser

foot to the top of the needle plate is 19.5 mm when the

sewing machine is stopped and the intermittent presser foot

(1) is raised.

Intermittent stroke range

11. STANDARD ADJUSTMENTS

4049M

5012Q

Table of Contents

Show Quick Links

Table of Contents