Installing The Feed Plate; Adjusting The Thread Wiper - Brother BAS-342G PS Instruction Manual

Direct drive programmable electronic pattern sewer, "perfect stitch"

Hide thumbs Also See for BAS-342G PS:

Table of Contents

11. STANDARD ADJUSTMENTS

11-10-1. Installing the feed plate

NOTE:

Install the feed plate so that the surface with the index mark is facing upward.

Place the rear edge of the feed plate (1) against the projection of base plate Y (2) (shaded section (A)) and use a 2 mm

diameter pin (such as a needle) to align the hole in the feed plate (1) with the hole in base plate Y (2); then tighten the two

bolts (3).

5007Q

1. Loosen the two screws (3) and shift the entire solenoid setting plate (4) up or down to adjust so that the thread wiper (2) is

15 mm in front of the needle center when the plunger (1) of the thread wiper solenoid is driven to the full stroke.

2. Loosen the screw (5) and adjust the position of the thread wiper (2) so that the distance from the thread wiper to the tip of

the needle is approximately 2 mm and the tip of the thread wiper (2) is approximately 3 mm from the center of the needle

when the thread wiper (2) passes below the needle during operation.

NOTE: Check that the thread wiper (2) does not touch the finger guard.

1892B

BAS-342G PS

Index mark

Approx. 2mm

Approx. 3mm

2773B

1893B

Table of Contents

Show Quick Links

Table of Contents