Setting 2-Step Operation For The Work Clamp - Brother BAS-342G PS Instruction Manual
Direct drive programmable electronic pattern sewer, "perfect stitch"
Hide thumbs
Also See for BAS-342G PS:
- Service manual (153 pages) ,
- Manual de instrucciones (86 pages) ,
- Instruction manual (84 pages)
Table of Contents
Advertisement
5-8. Setting 2-step operation for the work clamp
1st step
2nd step
Intermediate
1st step
position
2nd step
When these settings are made, the work clamp (1) can be
4009M
lowered in two steps.
1. Set memory switch No. 002 to "1".
(Refer to "7-2. Setting memory switches".)
2. With the work clamp (1) raised, loosen the wing screw
(2).
3. Move the work clamp stopper (3) up or down to determine
the intermediate position, and then tighten the wing screw
(2) to secure the work clamp stopper (3) in place.
4. Depress the work clamp switch (4) to the 1st step and
check the intermediate position for the work clamp.
5. Depress the work clamp switch (4) to the 2nd step to fully
lower the work clamp.
*
2-step work clamp operation is enabled when memory
switch No. 002 is set to "1".
*
Do not set memory switch No. 002 to "2".
4010M
<To return the work clamp to one-step operation>
1. Set memory switch No. 002 to "0".
(Refer to "7-2. Setting memory switches".)
2. With the work clamp (1) raised, loosen the wing screw (2).
3. Move the work clamp stopper (3) to its highest position,
and then tighten the wing screw (2) to secure the work
clamp stopper (3) in place.
4011M
BAS-342G PS
5. PREPARATION BEFORE SEWING
26
- Quick Links:
- Table of Error Codes
Hide quick links:
Advertisement
Table of Contents
