Setting The Height Of The Intermittent Presser Foot - Brother BAS-342G PS Instruction Manual
Direct drive programmable electronic pattern sewer, "perfect stitch"
Hide thumbs
Also See for BAS-342G PS:
- Service manual (153 pages) ,
- Manual de instrucciones (86 pages) ,
- Instruction manual (84 pages)
Table of Contents
Advertisement
6-7. Setting the height of the intermittent presser foot
You can use the operation panel to change the setting value for the intermittent presser foot height.
1
All indicators switch off
THREAD/CLAMP indicator illuminates
2
3
Ending setting mode
THREAD/CLAMP indicator switches off
Intermittent presser foot operation
During standby
When lowered
While sewing
MENU indicator switches off
<Changing modes>
6. USING THE OPERATION PANEL (BASIC OPERATIONS)
Press the THREAD/CLAMP key.
The sewing machine will switch to threading mode.
• " 1" will appear in the PROGRAM No. display and the
intermittent presser foot (1) will drop.
Press the
key.
The sewing machine will switch to intermittent presser foot height
setting mode.
• " 4" will appear in the PROGRAM No. display and the
intermittent presser foot (1) will rise to the setting value that
appears in the menu display.
(Intermittent presser foot height setting: 0.0 − 10.0)
Press the
or
key to set the intermittent presser foot
height.
• The intermittent presser foot (1) will be raised or lowered to the
height of the new value that has been set.
NOTE:
After making the setting, be sure to turn the pulley once by
hand and check that the intermittent presser foot (1) does not
touch the needle bar.
"
1" Threading mode
↑ ↓
"
4" Intermittent presser foot height setting mode
Press the THREAD/CLAMP key.
• The setting values will be memorized.
• The intermittent presser foot (1) will return to the status that it
was at before the sewing machine was switched to setting
mode.
1
Intermittent presser foot lift amount
2
Intermittent presser foot height
The settings can be made by the above
operations.
However, if the intermittent presser foot
height is set to a smaller setting than the
intermittent
intermittent presser foot will not drop in
order to prevent it from coming into contact
with the needle plate. (Refer to page 64.)
3
Intermittent stroke
Refer to "11-13. Changing the intermittent
stroke" when making the adjustment.
BAS-342G PS
4445Q 2158B
5225Q
4016M
presser
foot
stroke,
2763B
the
32
- Quick Links:
- Table of Error Codes
Hide quick links:
Advertisement
Table of Contents
