Threading The Upper Thread - Brother BAS-342G PS Instruction Manual

Direct drive programmable electronic pattern sewer, "perfect stitch"

Hide thumbs Also See for BAS-342G PS:

Table of Contents

5-3. Threading the upper thread

Thread the upper thread correctly as shown in the illustration below.

* When using threading mode for threading, the tension discs (1) will open so that the thread can be threaded more easily.

(Refer to following page.)

[If using cotton thread or spun thread]

2756B

• Turn the machine pulley (2) and raise the thread take-up (3) to its highest position before threading the upper thread.

(This will make threading easier and it will prevent the thread from coming out at the sewing start.)

• When threading the thread through the needle, allow a distance of approximately 45 mm between the needle hole and the

end of the thread.

If the trailing length of the thread is too long, it may cause the thread to become tangled.

[If using synthetic thread]

BAS-342G PS

5. PREPARATION BEFORE SEWING

Thread the upper thread

Needle cooler

2572B

2757B

Table of Contents

Show Quick Links

Table of Contents