Cisco 2948G - Catalyst Switch Hardware Installation Manual page 58
Hardware installation guide
Hide thumbs
Also See for 2948G - Catalyst Switch:
- Product support bulletin (3 pages) ,
- Configuration manual (614 pages) ,
- Software configuration manual (510 pages)
Table of Contents
Advertisement
Installing the Catalyst 2948G and 2980G Switches
Figure 3-1
Attaching the L Brackets
ST AT US
Ca tal ys
t 29 48 G
Step 3
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
3-8
The L brackets connect the switch chassis to the rack. You can mount the
L brackets to the front- or rear-mounting holes of the chassis, depending on which
end is in the front of the rack.
Note
The Catalyst 2948G switch is shown in the rack-mounting illustrations.
The rack-mounting procedure for the Catalyst 2980G switch is the same.
Figure 3-2
shows how to attach the front of the switch to the rack. You can also
attach the rear of the switch to the rack, depending on the configuration of your
rack.
Install the chassis in the rack as follows:
Position the switch chassis in the rack (see
a.
If the chassis front panel is to be in the front of the rack, insert the rear
•
of the chassis between the mounting posts.
If the rear of the chassis is to be in the front of the rack, insert the front
•
of the chassis between the mounting posts.
Align the mounting holes in the L bracket with the mounting holes in the
b.
equipment rack.
Secure the chassis using six 12-24 x 3/4-inch screws (three per side) through
c.
the elongated holes in the L bracket and into the threaded holes in the
mounting post.
d.
Use the tape measure and level to ensure that the chassis is installed straight
and level.
Chapter 3
Installing the Switch
Figure
3-2):
78-6286-05
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
