Table of Contents
Advertisement
Chapter 7
Installing the NM-CIDS
Required Tools
Installing the NM-CIDS
Installing the NM-CIDS Offline
Warning
Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Removing the NM-CIDS, page 7-11
•
•
Blank Network Module Panels, page 7-14
You need the following tools and equipment to install an NM-CIDS in a Cisco
modular router chassis slot:
•
#1 Phillips screwdriver or small flat-blade screwdriver
ESD-preventive wrist strap
•
Tape for DC circuit breaker handle
•
This section contains the following topics:
Installing the NM-CIDS Offline, page 7-7
•
•
Installing an NM-CIDS Using OIR Support, page 7-10
You can install the NM-CIDS in the chassis either before or after mounting the
router, whichever is more convenient.
Only trained and qualified personnel should be allowed to install or replace this
equipment. To see translations of the warnings that appear in this publication,
refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
ESD can damage equipment and impair electrical circuitry. Always follow ESD
prevention procedures when removing and replacing cards. See
ESD Environment, page
1-21, for more information.
Installation and Removal Instructions
Working in an
7-7
Advertisement
Table of Contents
Troubleshooting
