Cisco AS5350 - Universal Access Server Configuration Manual page 164
Universal gateway software configuration guide
Hide thumbs
Also See for AS5350 - Universal Access Server:
- Installation manual (102 pages) ,
- Quick start manual (65 pages) ,
- Quick reference manual (38 pages)
Table of Contents
Advertisement
Getting Started
Step 9
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [no]: yes
Community string [public]:
Configure IP? [no]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure bridging? [no]:
Note
Enter the letter corresponding to the ISDN switch type that matches your telco switch type or press
Step 10
Enter to accept the default.
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [d]:
Step 11
Enter yes to allow users to dial in via ISDN or analog modems.
Do you intend to allow users to dial in? [yes]: yes
There are 16 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller E1 0,1,..etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Enter the number of controllers you will be using for the PRI configuration or press Enter to configure
Step 12
all controllers.
Enter # of controllers, you will be using for PRI configuration [16]:
Configuring controller parameters:
Step 13
Press Enter for every slot, port, and channel.
Configuring controller E1 1/0:
Configuring PRI on this controller.
Configuring controller E1 1/1:
Configuring PRI on this controller.
.
.
.
.
Configuring controller E1 2/6:
Configuring PRI on this controller.
Configuring controller E1 2/7:
Configuring PRI on this controller.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
-14
If you answer no to IGRP, you are prompted to configure RIP.
in software corresponds to Port 0,1,..etc
Appendix
OL-3418-02 B0
- Quick Links:
- Table of Contents
- Basic Hardware Architecture
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
