Configure Dial Peers - Cisco AS5350 - Universal Access Server Configuration Manual
Universal gateway software configuration guide
Hide thumbs
Also See for AS5350 - Universal Access Server:
- Installation manual (102 pages) ,
- Quick start manual (65 pages) ,
- Quick reference manual (38 pages)
Table of Contents
Advertisement
Configuring Basic VoIP
E1 R2 Signaling
R2 is an international signaling standard for channelized E1 networks used in Europe, Asia, and
South America, equivalent to channelized T1 signaling in North America. There are two elements to R2
signaling:
•
•
If you have ISDN PRI voice ports, be sure to complete
page
T1 CAS Signaling
Channel-associated signaling (CAS) occurs in-band within the data channel, rather than on a separate
signaling channel as is the case (on the D channel) with ISDN PRI. For T1 CAS, specify parameters such
as frame type and line code.
Configure Dial Peers
Your next step in preparing to set up dial peers is to determine the configurable options that you want to
enable.
Configurable Options
Configurable options are the attributes to be applied to calls handled using that dial peer. These typically
include, at a minimum, required quality of service, codec for voice encoding, and whether voice-activity
detection is to be enabled. The following attributes, for example, are typical in a VoIP dial peer:
req-qos best-effort
codec g711ulaw
vad
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
6-8
Line signaling (supervision), including R2 digital, R2 analog, and R2 pulse
R2 interregister signaling (call-setup control), including compelled, noncompelled, and
semi-compelled
4-6. Configure signaling types and, if necessary, set parameters unique to specific countries.
Chapter 6
Configuring Voice over IP
"Configuring E1 R2 Signaling" section on
OL-3418-02 B0
- Quick Links:
- Table of Contents
- Basic Hardware Architecture
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
