hit counter script

Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 32

Carrier routing system
Hide thumbs Also See for CRS-1 - Carrier Routing System Router:
Table of Contents

Advertisement

Connecting and Communicating with the Router
Figure 2-1
Communication Ports on the RP for a Cisco CRS-1 16-Slot Line Card Chassis
Local terminal or
terminal server for
CLI communication.
Remote terminal for
CLI communication.
Network
Remote CLI, CWI,
XML, or SNMP
communication.
The first time a router is started, you must use a direct connection to the Console port to connect to the
router and enter the initial configuration (Initial configuration is described in
New Cisco CRS-1
that you can use a network workstation to manage and configure the router. When you use a direct
connection to the Console port, CLI commands are entered at a terminal or at a computer running
terminal emulation software. A direct Console port connection is useful for entering initial
configurations and performing some debugging tasks.
After the initial configuration, most router management and configuration sessions use a Telnet session
over an Ethernet network connected to the Management Ethernet interface. SNMP agents and the CWI
also use the network connection.
The modem connection can be used for remote communications with the router and serves as an alternate
remote communications path if the Management Ethernet interface fails.
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
2-2
RJ-45 cable
RJ-45 cable
Management Ethernet connection
for out-of-band network communciation
Router.") The initial configuration configures the Management Ethernet interface so
Chapter 2
Cisco IOS XR Basic Configuration Management
RP
Console
AUX
HDD
PC Card
(disk1:)
Optical GigE for control plane:
CNTL ETH 0
not user-configurable
CNTL ETH 1
MGMT ETH
Primary
Status
Chapter 4, "Bringing up a

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Crs-1 series

Table of Contents