Environmental Reporting Features; Troubleshooting Cables, Connections, And Interface Cards - Cisco 1841 - 3G Bundle Router Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 1841 - 3G Bundle Router:
- User manual (29 pages) ,
- Datasheet (11 pages) ,
- Configuration manual (198 pages)
Table of Contents
Advertisement
Chapter 8
Troubleshooting Cisco 1800 Series Routers (Modular)
Environmental Reporting Features
If the router is operating at an abnormally high temperature, consider the following causes:
•
•
•
Take steps to correct the problem. See the
Troubleshooting Cables, Connections, and Interface Cards
Network problems can be caused by cables, cable connections, or interface cards, or by external devices
such as a modem, transceiver, hub, wall jack, WAN interface, or terminal. Check for the following
symptoms to help isolate the problem.
•
•
•
•
•
•
OL-5876-03
Fan failure
Air conditioner failure in the room
Air blockage to cooling vents
Card is not recognized by the router.
Make sure that the card is firmly seated in its slot.
–
Check the LEDs on the card. Each card has its own set of LEDs.
–
Make sure that you have a version of Cisco IOS software that supports the card.
–
Card is recognized, but interface ports do not initialize.
Make sure that the card is firmly seated in its slot.
–
–
Check external cable connections.
Make sure that you have a version of Cisco IOS software that supports the card. Check the
–
software requirements for the affected card, which can be found in the configuration note for
the card.
Router does not boot properly, or constantly or intermittently reboots.
Make sure that the card is firmly seated in its slot.
–
–
Check the router chassis or software.
Router boots, but the console screen is frozen.
–
Check the external console connection.
Verify that the parameters for your terminal are set as follows:
–
(a) The same data rate as configured for the router (9600 baud is the default)
(b) 8 data bits
(c) 1 stop bit
(d) No parity generated or checked
Router powers on and boots only when a particular card is removed.
Check the card. See the
–
page 1-14
and the
"Obtaining Documentation and Submitting a Service Request" section on
page 15
of the
"Introduction to Cisco 1800 Series Routers (Modular) Hardware
Documentation"
document for warranty and customer service contact information.
Router powers on and boots only when a particular cable is disconnected.
"Site Environment" section on page
"Cisco One-Year Limited Hardware Warranty Terms" section on
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
Problem Solving
3-4.
8-3
Advertisement
Table of Contents
Troubleshooting
