Items Not Included In The Box For The Cisco 1861 Integrated Services Router; Required Tools And Equipment For Installation And Maintenance - Cisco 1841 - 3G Bundle Router Hardware Installation Manual
Hardware installation guide
Hide thumbs
Also See for 1841 - 3G Bundle Router:
- User manual (29 pages) ,
- Datasheet (11 pages) ,
- Configuration manual (198 pages)
Table of Contents
Advertisement
Chapter 3
Preinstallation Requirements and Planning for Cisco 1800 Series Routers (Modular)
Inspect all items for shipping damage. If anything appears to be damaged, or if you encounter problems
installing or configuring your router, contact customer service.
Items not Included in the Box for the Cisco 1861 Integrated Services Router
You may need individual items in this list which are not shipped in the box:
•
•
•
•
•
Required Tools and Equipment for Installation and Maintenance
You need the following tools and equipment for installing and upgrading the router and its components:
•
•
•
•
•
In addition, depending on the type of modules you plan to use, you might need the following equipment
to connect a port to an external network:
•
•
•
•
•
•
NT1 device for ISDN BRI S/T interfaces (if not supplied by your service provider)
OL-5876-03
–
Assembly hardware (screws)
Installing Components for Cisco 1861 Integrated Services Router
–
Cisco Unified IP phones
Cables for connecting phones
Cable for connecting external audio device to the 3.5-mm MoH port
Cables for WAN interfaces, voice interfaces, or additional LAN interfaces
PC with Microsoft Internet Explorer 6.0 or later, for using web-based system management tools
ESD-preventive cord and wrist strap
Number 2 Phillips screwdriver
Flat-blade screwdrivers: small, 3/16-inch (0.48 centimeter) and medium, 1/4-inch (0.63 centimeter)
For installing or removing modules
–
–
For removing the cover if you are upgrading memory or other components
Wire crimper
AWG 14 wire for connecting the router chassis to earth ground
Cables for connection to WAN and LAN ports (dependent on configuration)
For more information on cable specifications, see the online document
Note
Access Router Cable
Ethernet hub or PC with a network interface card for connection to Ethernet (LAN) ports
Console terminal (an ASCII terminal or a PC running terminal emulation software) configured for
9600 baud, 8 data bits, no parity, and 1 stop bit
Modem for connection to the auxiliary port for remote administrative access
Data service unit (DSU) or channel service unit/data service unit (CSU/DSU) as appropriate for
serial interfaces
External CSU for any CT1/PRI modules without a built-in CSU
Required Tools and Equipment for Installation and Maintenance
Specifications, which is located on Cisco.com.
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
Cisco Modular
3-7
Advertisement
Table of Contents
Troubleshooting
