Additional Information; Troubleshooting; General - Yamaha MCR-040 Owner's Manual
Owners manual
Hide thumbs
Also See for MCR-040:
- Owner's manual (136 pages) ,
- Service manual (101 pages) ,
- Owner's manual (48 pages)
Table of Contents
Advertisement
ADDITIONAL INFORMATION
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
General
Problem
This unit fails to turn
The power cable is not connected or the
on or enters the
plug is not completely inserted.
standby mode soon
This unit has been exposed to a strong
after the power is
external electric shock (such as lightning
turned on.
or strong static electricity).
The unit does not
operate properly.
No sound.
No appropriate input source has been
selected.
Speaker connections are not secure.
The mute function may be on.
The volume is turned down.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The power is
The sleep timer may be set.
suddenly turned off.
The unit is left turned on for 1 hour
without playback or any other operation
being performed.
The power was turned on by the timer
and elapsed specified running time.
MCR-140: The iPod selected as the input
source is disconnected from the
transmitter, or does not output sound for a
certain period.
The clock setting has
The power cable has been disconnected.
been cleared.
Sound is heard from
Incorrect cable connections.
the speaker on one
side only.
There is noise
This unit is too close to the digital or
interference from
high-frequency equipment.
digital or radio
frequency equipment.
The following status messages appear only if you are using MCR-140.
Status message
SubWoofer Link
Wireless connection between the
subwoofer and the unit is established.
SubWooferUnlink
Wireless connection between the
subwoofer and the unit is disconnected.
Wireless Error
There is a problem with the internal
circuit of this unit.
TROUBLESHOOTING
Cause
Connect the power cable firmly.
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and
then use it normally.
Select an appropriate input source with INPUT on
the front panel (or the source buttons on the remote
control).
Secure the connections.
Cancel the mute function.
Turn up the volume.
Play a source whose signals can be reproduced by
this unit.
This is not malfunction. Turn on the unit and play the
source again.
Connect the power cable, and set the clock again.
Connect the cables properly. If the problem persists,
the cables may be defective.
Move this unit farther away from such equipment.
Cause
Disconnect the power cable and contact the nearest
authorized Yamaha dealer or service center.
Remedy
Remedy
Page
4
—
—
4
6
—
3
—
—
4
—
Page
—
17
En
Hide quick links:
Advertisement
Table of Contents
