Table of Contents
Advertisement
Chapter 2
Installation
Place the switch onto the mounting screws and slide the switch forward until it locks in place, as shown
Step 7
in
Figure
Figure 2-4
1
2
Installing the Switch on a Wall
Follow the steps in this section to install the switch to a wall:
The switch can be wall-mounted with the front panel facing up or down. The steps in this section show
Note
how to mount the switch with the front panel facing down (as shown in
Figure 2-6 on page
template 180 degrees.
Locate the screw template. The template is used to align the mounting screw holes.
Step 1
Step 2
Position the screw template so that the two side-by-side slots face toward the ceiling, as shown in
Figure
For the best support of the switch and cables, make sure the switch is attached securely to a wall stud or
to a firmly attached plywood mounting backboard.
Note
Do not attach the screw template to the wall yet.
OL-6157-01
2-4.
Mounting the Switch Under a Desk
1
2
ES
RI
SE
4 0
2 9
st
al y
at
C
3
3
Desktop
Slides on this way
4
Screws
Wall
2-11.) If you want to mount the switch with the front panel facing up, rotate the screw
2-5. This ensures that the power cord faces toward the floor after they are connected.
D
SP
LX
DP
T
STA
ST
SY
Figure 2-5 on page 2-10
Catalyst 2940 Switch Hardware Installation Guide
Installing the Switch
4
and
2-9
- Quick Links:
- Setting up the Switch
- Installation
Hide quick links:
Advertisement
Table of Contents
