Join A Shared-Line Call; Place And Establish Conference Call; Place Meetme Conference Call; End A Conference Call - Cisco 7975G - Unified IP Phone VoIP User Manual
Unified ip phone
Hide thumbs
Also See for 7975G - Unified IP Phone VoIP:
- Software manual (302 pages) ,
- Administration manual (217 pages) ,
- Troubleshooting and maintenance (25 pages)
Table of Contents
Advertisement
Live Record a Call
Call initiators can use the LiveRcd soft key to record an active call, private line or conference call. To record a call, use this
method:
1. Press the LiveRcd. This puts the other party on-hold and initiates a call to the configured live record number.
2. Press the LiveRcd again to stop the recording.
Join a Shared-Line Call
User can join a call on a shared line using the cBarge softkey.
To join the shared-line call, use the following method:
1. Highlight the remote-in-use call that you want to join.
2. Press the more to navigate to cBarge and press cBarge.
Place and Establish Conference Call
To place a conference call:
1. During a call, press the more soft key and then the Confrn soft key to open a new line and put the first party on hold.
2. Place a call to another number.
3. When the call connects, press Confrn again to add the new party to the call.
To establish a conference call between two- and three-party calls to a Cisco Unified IP phone, one active and the other on hold:
• Press the Confrn soft key on the Cisco Unified IP phone.
To establish a conference call between two- and three-party calls already present on a Cisco Unified IP phone, using separate
line buttons, one active and the other on hold:
1. Press the Confrn soft key on the Cisco Unified IP phone.
2. Press the Line button of the call you want to add to the conference.
Your system administrator will have configured the system for three-party or eight-party ad-hoc conferences.
Note
Place MeetMe Conference Call
To place a MeetMe conference call:
1. Obtain a MeetMe conference number from your administrator.
2. Distribute the MeetMe conference number to all the participants.
3. Go offhook, press the MeetMe softkey, and dial the MeetMe conference number. All other participants join the meeting by
dialing into the MeetMe conference number.
• To end the MeetMe conference call, all participants must hang up the handset or press the EndCall soft key.
End a Conference Call
• To end the conference call:
1. Hang up the handset, or press the EndCall soft key.
Note
Depending on configuration, when the conference call initiator disconnects, the conference call terminates.
Alternate Methods to End Conference Call
Call initiators may use one of the following methods (functionality will vary according to your system configuration):
• To disconnect from the conference, hang up the handset. The other parties remain on the conference call.
14
Advertisement
Table of Contents
