Table of Contents
Advertisement
Cisco NAC Appliance Licensing
1
2
3
Step 4
Lift the locking levers on the slide rails and push the CAM/CAS all the way into the rack until it clicks
into place (see
Figure 2-16
1
Cisco NAC Appliance Licensing
You need at least one Clean Access Manager license and one Clean Access Server license for your Cisco
NAC Appliance system to work. Both licenses are installed via the Clean Access Manager
administration web console. For Out-of-Band (OOB) deployments, you must add both the OOB CAS
license and the CAS as an Out-of-Band device to the CAM to access the OOB Management module of
the CAM web console.
•
•
Cisco NAC Appliance Hardware Installation Guide
2-26
Extend the slide rails forward
Chassis nail heads
Rear slide rail slots
Figure
2-16).
Push the NAC-3355/3395 Into the Rack
Locking levers
For instructions on how to obtain new license(s) for your system, see
Contract/Licensing
Support.
For instructions on how to install licenses for your system (after initial configuration is complete),
see
Install CAM License, page 3-13
4
Lower the CAM/CAS into position
5
Front latches
1
2
2
Push the CAM/CAS into the rack
and
Add Additional Licenses, page
Chapter 2
Preparing for Installation
Cisco NAC Appliance Service
3-15.
OL-20326-01
Hide quick links:
Advertisement
Table of Contents
