Table of Contents
Advertisement
Clearing CMOS Settings
CAUTION:
safety instructions located in the Product Information Guide.
1 Follow the procedures in "Before You Begin" on page 103.
NOTE:
the CMOS setting.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 105).
3 Reset the current CMOS settings:
Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system
a
board based on your computer model:
•
"Inspiron 530s" on page 191
•
"Inspiron 530sa" on page 191
•
"Inspiron 530sb" on page 192
•
"Inspiron 530sc" on page 192
•
"Inspiron 530sd" on page 193
Remove the jumper plug from the CMOS jumper (CLEAR CMOS)
b
pins 2 and 3.
Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1
c
and 2 and wait approximately five seconds.
Remove the jumper plug and replace it on the CMOS jumper
d
(CLEAR CMOS) pins 2 and 3.
4 Replace the computer cover (see "Replacing the Computer Cover" on page 174).
NOTICE:
device and then plug it into the computer.
5 Connect your computer and devices to electrical outlets, and turn them on.
194
Appendix
Before you begin any of the procedures in this section, follow the
The computer must be disconnected from the electrical outlet to clear
To connect a network cable, first plug the cable into the network port or
- Quick Links:
- Front View of the Computer
- Inspiron 530S
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
