Common Ethernet Management Tasks
exit-address-family
!
address-family ipv6
exit-address-family
!
(some output removed for brevity)
Viewing Detailed VRF Information for the Management Ethernet VRF
To see detailed information about the Management Ethernet VRF, enter the show vrf detail Mgmt-intf
command:
Router# show vrf detail Mgmt-intf
VRF Mgmt-intf (VRF Id = 4085); default RD <not set>; default VPNID <not set>
Interfaces:
Address family ipv4 (Table ID = 4085 (0xFF5)):
No Export VPN route-target communities
No Import VPN route-target communities
No import route-map
No export route-map
VRF label distribution protocol: not configured
VRF label allocation mode: per-prefix
Address family ipv6 (Table ID = 503316481 (0x1E000001)):
No Export VPN route-target communities
No Import VPN route-target communities
No import route-map
No export route-map
VRF label distribution protocol: not configured
VRF label allocation mode: per-prefix
Setting a Default Route in the Management Ethernet Interface VRF
To set a default route in the Management Ethernet Interface VRF, enter the following command
ip route vrf Mgmt-intf 0.0.0.0 0.0.0.0 next-hop-IP-address
Setting the Management Ethernet IP Address
The IP address of the Management Ethernet port is set like the IP address on any other interface.
Below are two simple examples of configuring an IPv4 adress and an IPv6 address on the Management
Ethernet interface.
IPv4 Example
Router(config)# interface GigabitEthernet 0
Router(config-if)# ip address A.B.C.D A.B.C.D
IPv6 Example
Router(config)# interface GigabitEthernet 0
Router(config-if)# ipv6 address X:X:X:X::X
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
9-4
Gi0
Chapter 9
Using the Management Ethernet Interface
OL-16506-10