Table of Contents
Advertisement
Configuring 1-Port G.SHDSL WAN Interface Card
The following sample output shows a WIC configured as central office equipment, and the line is up:
Router# show dsl interface atm 0/0
Globespan G.SHDSL Chipset Information
Equipment Type:
Operating Mode:
Clock Rate Mode:
Reset Count:
Actual rate:
Modem Status:
Noise Margin:
Loop Attenuation:
Transmit Power:
Receiver Gain:
Last Activation Status:No Failure
CRC Errors:
Chipset Version:
Firmware Version:
Farend Statistics since CO boot-time:
CRC Errors:
Errored Seconds: 0
Severly ES:
Un Available S:
Loss Of Sync S:
The following sample output shows a WIC configured as customer premises equipment, and the line is
up:
Router# show dsl interface atm 0/0
Globespan G.SHDSL Chipset Information
Equipment Type:
Operating Mode:
Clock Rate Mode:
Reset Count:
Actual rate:
Modem Status:
Noise Margin:
Loop Attenuation:
Transmit Power:
Receiver Gain:
Last Activation Status:No Failure
CRC Errors:
Chipset Version:
Firmware Version:
Configuration Examples
Configuration examples are provided in the following sections:
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-64
Central Office
G.SHDSL
Auto rate selection Mode
2
2320 Kbps
Data
43 dB
0.0 dB
13.5 dB
204.8000 dB
0
1
R1.0
0
0
48
0
Customer Premise
G.SHDSL
Auto rate selection Mode
1
2320 Kbps
Data
42 dB
0.0 dB
13.5 dB
204.8000 dB
0
1
R1.0
Configuration in CPE Mode Example, page A-25
Configuration in CO Mode Example, page A-27
Chapter 3
Configuring with the Command-Line Interface
OL-1957-03
Hide quick links:
Advertisement
Table of Contents
