Table of Contents
Advertisement
Configuring 1-Port G.SHDSL WAN Interface Card
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Configuring ILMI on the DSLAM Connected to the ADSL WAN
The ILMI protocol allows DSLAMs to be used for ATM address registration across an ATM
User-Network Interface (UNI). If ILMI is configured on the G.SHDSL WIC, the ATM PVC must be
configured on the DSLAM. All switch terminating connections use interface 0/0 to connect to the switch
CPU.
For information about configuring the DSLAM, see the
NI-2.
Verifying ATM Configuration
Use the following commands to verify your configuration:
•
•
•
•
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-62
Command
Router(config-if)#
equipment-type {co | cpe}
Router(config-if)# dsl linerate
{kbps | auto }
Router(config-if)# exit
Router(config)# exit
Router# show interface atm 1/0
Router# clear interface atm 1/0
To verify current configuration and to view the status for all controllers, use the show
running-config command.
To view ATM controller statistics, use the show controllers atm slot/port command.
To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up.
To help identify ATM related events as they are generated, use the debug atm events command.
To indicate which interfaces are having trouble, use the debug atm errors command.
To identify an entry for the ATM interface you configured and to show an entry for the ATM slot/port
you configured, use the show ip route command.
Chapter 3
Configuring with the Command-Line Interface
Purpose
Configures the DSL interface to function as central office
equipment or customer premises equipment:
•
co—The WIC functions as central office equipment
and can interface with another G.SHDSL WIC
configured as cpe.
cpe—The WIC functions as customer premises
•
equipment and can interface with a DSLAM or with
another G.SHDSL WIC configured as co.
The default is cpe.
Configures the DSL line rate:
kbps—Line rate (data transfer rate) in kilobits per
•
second. Allowable entries are 72, 136, 200, 264,
392, 520, 776, 1032, 1160, 1544, 2056, and 2312.
auto—The WIC automatically trains for an optimal
•
line rate by negotiating with the far-end DSLAM or
WIC.
The default is auto.
Exits from ATM interface configuration mode.
Exits from global configuration mode.
Verifies the ATM interface configuration.
Permits the configuration changes to take effect.
Configuration Guide for Cisco DSLAMs with
OL-1957-03
Hide quick links:
Advertisement
Table of Contents
