Table of Contents
Advertisement
Configuring 1-Port G.SHDSL WAN Interface Card
Configure the Modem for Dial-In
To configure the modem lines for dial-in, perform the following tasks, beginning in global configuration
mode:
Step 1
Step 2
Step 3
Step 4
Configure the Modem for Dial-Out
To configure the modem lines for dial-out, perform the following tasks, beginning in global
configuration mode:
Step 1
Step 2
Step 3
This configuration procedure ensures that a user trying to dial out using Telnet is connected to the first
free line in the rotary group.
Configuration Example
Refer to
for an example of the configuration.
Configuring 1-Port G.SHDSL WAN Interface Card
This section describes how to configure the Multirate Symmetrical High-Speed Digital Subscriber Line
(G.SHDSL) feature supported on the 1-port G.SHDSL WAN interface card (WIC) (WIC-1SHDSL) on
Cisco 2600 series and Cisco 3600 series routers in Cisco IOS Release 12.2(4)T.
This section includes the following sections:
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-58
Command
line start-range end-range
autoseect during-login
autoselect ppp
modem inout
Command
line start-range
end-range
rotary number
transport input telnet
theAppendix A, "Cisco 3640 Central Site Configuration to Support ISDN and Modem Calls"
Restrictions, page 3-60
Prerequisites, page 3-60
Chapter 3
Configuring with the Command-Line Interface
Description
Select the modem lines for dial-in and switch to the line
configuration mode.
Set the router to display a login prompt to modem
callers.
Set the router to shift automatically to PPP mode if it
detects an incoming PPP packet.
Configure the line for both incoming and outgoing calls.
Description
Select the modem lines for dial-out and switch to
the line configuration mode.
Set the router to use previously-defined rotary
group.
Configure the router to accept inbound Telnet
connections.
OL-1957-03
Hide quick links:
Advertisement
Table of Contents
