Table of Contents
Advertisement
AM
Problem
Cause
The desired station
The signal is weak, or the antenna
cannot be tuned into
connections are loose.
with the automatic
tuning method.
Automatic station
Automatic station preset is not
preset does not
available for AM stations.
work.
Continuous
The supplied AM loop antenna is
crackling and
not connected.
hissing noises are
The noises may be caused by
heard.
lightning, fluorescent lamps,
motors, thermostats, or other
electrical equipment.
Buzzing and whining
A TV set is being used nearby.
noises are heard.
See
Remedy
page
Adjust the AM loop antenna orientation.
21
Use the manual tuning method.
30
Use manual station preset.
32
Connect the AM loop antenna correctly
21
even if you use an outdoor antenna.
It is difficult to completely eliminate noise,
21
but it can be reduced by installing and
properly grounding an outdoor AM antenna.
Move this unit away from the TV set.
—
Remote control
Problem
Cause
The remote control
Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
The batteries are weak.
The remote control ID of the
remote control and this unit do not
match.
External components
The remote control code is not
cannot be controlled
correctly set.
using the remote
control.
APPENDIX
Troubleshooting
See
Remedy
page
The remote control will function within a
—
maximum range of 20 ft / 6 m, and no more
than 30 degrees off-axis from the front
panel.
Adjust the lighting angle, or reposition this
—
unit.
Replace all batteries.
4
Match the remote control ID of this unit and
56
the remote control.
Set the remote control code correctly using
—
"Remote control code
search" on the CD-
ROM.
Try setting another code for the same
—
manufacturer using
"Remote control code
search" on the CD-ROM.
If this unit does not work when you press
—
j
Cursor B / C / D / E
(on the remote
control), do the following.
When the key does not work during DVD
d
disc menu operation: press the
Input
selector
(on the remote control) again.
When the key does not work during Option
—
menu/Setup menu operation: press the key
corresponding to the current menu operation
again.
Even if the remote control code is correctly
—
set, there are some models that do not
respond to the remote control.
64
En
Hide quick links:
Advertisement
Table of Contents
