Ion cleansing with moisturizing support device (19 pages)
Summary of Contents for Hitachi CM-N48000BF
Page 1
INSTRUCTIONS HITACHI Ion cleansing with moisturizing support device CM-N48000BF For household use only RECHARGEABLE 100-240V AC FREE VOLTAGE 日本製造 Made in Japan...
Page 5
English Safety precautions ● Precautions described here are intended for safe and correct use of this product and are to prevent injury and damage to you and others before they occur. ● Precautions are classified as follows. Make sure to observe the precautions because they are all important in relation to safety. Indicates an imminently dangerous situation in which improper handling may result in death or serious injury to a user.
Page 6
Do not use this product on the following regions. (Cause of accident or trouble) - Regions where orthopedic treatment was given - Eyeballs and upper eyelids - Wound sites - Facial melanoderma - Mucosal regions, such as inside the mouth - Regions irritated due to pimples or skin rash - Lips - Regions which suffer from sensation of pain or perception disorder...
Page 7
Do not insert or remove the power plug in/from the outlet with wet hands. (Cause of failure or short circuit) Use with wet hands prohibited This mark means that this appliance should not be used near water contained in bath-tubs, basins or other vessels. Do not wash or splash water on this product.
Page 8
Names of parts and their functions (Fig. 1) Heating dimple head (titanium material) Buzzer (Switching sound/ready Attach cotton and apply it to your skin. sound/warning sound/abnormality The device vibrates while being used in detection sound/finish sound/ modes other than “Cool.” indicating timer sound) Mode indicator lamp Every time the switch or button is...
Page 9
2. After the standard charging time (1.5 hours) has elapsed, pull out the power adaptor from the electric outlet and the main body. (Fig. 3) Pull out holding the plug portion. This device is for rechargeable use only. ● It cannot be powered on with the power adaptor connected. ●...
Page 10
3 Attach cotton to the body of the device. (Fig.4) The narrower side of the ring should be upward. Cotton (1)Remove the protection seal from the heating dimple head. (2)Place cotton over the head and attach it with the included ring. Use commercially available cotton.
Page 11
Example for use Press the mode switch button and set the mode of your preferred treatment. Quick tighten-up treatment (Required time: approximate 2 minutes) ● Step 4 “COOL” When you want to tighten your pores or cool down your skin before applying make up, you can just use “COOL.” After 10-second preparation for cooling, it only takes approximate one minute and 50 seconds to tighten the pores of your skin. Press the mode switch button to set to “COOL.”...
Page 12
Weekly full course (Required time: approximate 11 minutes) ● Step 1 "HOT CLEANSING" ● Step 2 "HOT MOISTURIZE" ● Step 3 “HOT MASK” (use of sheet mask) ● Step 4 “COOL” Care for your skin once or twice a week by using all modes. Fine vibrations in “Hot Mask (use of sheet mask)”...
Page 13
CAUTION Unless you apply the cotton to your skin while touching the back plate, the device will not vibrate. (skin sensing function) If the heating dimple head is not vibrating, the device is not working. If you leave the device as it is for about 3 minutes without vibration, the device will automatically switch "Off."...
Page 14
4 Choose "the strength" of electrical potential with the Level switch button. Switch the "strength" with the Level switch button according to the condition of your skin. ● Every time the level indicator button is pressed, the “L”,”M” and “H” of the electrical potential will be switched.
Page 15
1 Apply a gel-like moisturizing product or thick toner that you would normally use onto the heating dimple head and smoothen it over the entire head with your fingers. (Fig. 11) Moisturizing product 2 Press the power switch. (Fig.10) ● The level indicator lamp will be turned on, and “HOT MOISTURIZE”...
Page 16
6 After 3 minutes have elapsed, the device will automatically shut off. (Auto shutoff function) ● The finish sound will inform you. 7 Wipe off the moisturizing product on the heating dimple head and the body of the device with a tissue. Step 3 “HOT MASK”...
Page 17
● Apply the heating dimple head gently to the face and slowly move the device by sliding it from the center of the face to the outer side. Do not keep the heating dimple head on the same area of skin, it is necessary to move it around.
Page 18
CAUTION ● Do not slide the cooling head over the skin. ● Do not keep the cooling head in the same area of the skin, but move it around. The cooling effect of the cooling head may be lessened. 4 After one minute and 50 seconds have elapsed, the device will be automatically shut off. (Automatic shutoff function) ●...
Page 19
Do not leave in a water splashing area or an area with significant humidity, such as a bath. (Cause of short-circuits or failure) Do not wind the power cord around the power adaptor or the main body. (Cause of damage to cord) ★Do not leave in an area subject to direct sunlight (inside of a vehicle in CAUTION summer, etc.) or near heaters.
Page 20
How to remove the lithium ion battery 1. Hold the power switch and level switch buttons simultaneously for 5 seconds or more, and all indicator lamps light and then the mode and level indicator lamps light sequentially. Leave it until they turn off. 2.
Page 21
NOTICE Attention for Use ● Make sure to hold the main body of the product with your hand touching back plate and apply the of the product heating dimple head to your skin. Otherwise, the product will not be operated. Back plate About Skin Testing Function ●...
Page 22
FAQs Questions Answers ・ Check the intensity level. If it is set on "H" level, Tingling sensation is felt on the skin. press the level switch button to switch to "L" level. ・ If toner in the cotton pad wears off, replenish it again. ※ If you still feel uncomfortable on the skin, stop using the product immediately and consult a dermatologist.