Ice cube tray
Use the ice cube tray to make ice
cubes.
Making ice cubes
Use only drinking water to make ice
cubes.
Fill the ice cube tray with drinking
1.
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
To loosen the ice cubes, twist the
2.
ice cube tray slightly or hold it
briefly under flowing water.
Basic operation
7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 16
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for ten seconds.
a The appliance begins to cool.
a A warning signal sounds and the
temperature display (freezer com-
partment) and
the freezer compartment is still too
warm.
Switch off the warning signal using
2.
.
goes out as soon as the set
a
temperature has been reached.
Set the required temperature.
3.
→ Page 19
flash because
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
the housing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Select the refrigerator compart-
1.
ment using
Press
/
repeatedly until the
2.
temperature display (refrigerator
compartment) shows the required
temperature.
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
To increase the temperature, slide
2.
the temperature controller in the
direction.
→ Fig.
13
Basic operation en
for ten seconds.
.
19