Table of Contents
Advertisement
DRIVE CHAIN STOPPER INSPECTION/FRONT FORK INSPECTION/
FRONT FORK OIL SEAL AND DUST SEAL CLEANING
1
• Tighten the axle nut while pushing down
the drive chain.
• Tighten the locknuts.
DRIVE CHAIN STOPPER INSPECTION
1. Inspect:
2. Replace:
a
1
EC36C000
FRONT FORK INSPECTION
1. Inspect:
EC36D001
FRONT FORK OIL SEAL AND DUST SEAL
CLEANING
1. Remove:
NOTE:
Use a thin screw driver, and be careful not to
damage the inner fork tube and dust seal.
2. Clean:
NOTE:
• Clean the dust seal and oil seal after every
run.
• Apply the lithium soap base grease on the
inner tube.
3 - 42
Axle nut:
125 Nm (12.5 m • kg, 90 ft • lb)
Locknut:
16 Nm (1.6 m • kg, 11 ft • lb)
• Drive chain stopper 1
Wear indicator groove a has almost dis-
appeared → Replace.
• Drive chain stopper
7 Nm (0.7 m · kg, 5.1 ft · lb)
• Front fork smooth action
Operate the front brake and stroke the
front fork.
Unsmooth action/oil leakage → Repair or
replace.
• Protector
• Dust seal 1
• Dust seal a
• Oil seal b
INSP
ADJ
Advertisement
Table of Contents
