Setth N Up Speaker Parameters; Step 1: Display The Setting Menu; Step 2: Set The Speaker Status Arid Size; Step 3: Set The Distance From The Listening Point - Yamaha RX-V367 Owner's Manual
Av receiver
Hide thumbs
Also See for RX-V367:
- Service manual (106 pages) ,
- Owner's manual (61 pages) ,
- Owenrs manual (57 pages)
Table of Contents
Advertisement
[]
When you have finished connecting your speakers,
configure this unit so that they output sound normally.
Carry out the following steps to configure this unit.
STEP 1: Display the setting menu
Display the Setup menu from which you can configure
all settings for this unit, and then display the menu for
speaker settings.
STEP 2: Set the speaker status and size
Set the size and connection status of speakers and
subwoofers, and whether to designate a specific speaker
(or subwoofer) for low-frequency sound.
STEP 3: Set the distance
from the listening
point
Set the distance between the speakers and the listening
point so that the sound from each speaker reaches the
listening point at the appropriate timing.
STEP 4: Playback a test tone
Playback a test tone to allow you to configure sound
volumes while listening to the actual effect your settings
are having.
STEP 5: Adjust the volume
Adjust the volume for each speaker and configure them
so that the sound is balanced.
STEP1: Display the settin# menu
Switch this unit on.
Press []SETUP
on the remote control.
The Setup menu that allows you to configure all
parameters on this unit appears. ;2;{
#_ Check that "Speaker Setup" appears and
_9 press _ENTEFL
This completes step 1.
STEP2: Set the speaker status and
The settings in step 2 are not necessary with the
following speaker configuration:
- Front speaker: woofer diameter is 16 cm or larger
- Center/surround speakers: woofer diameter is 16 cm or
smaller
- Subwoofer: connected
Check that "Config"
appears and press
_ENTEFL
"{bJ _ : See the seclion "Setting various ftmctinns (Setup memO" for
details on the Setup metal (_,p. 40).
En
22
Advertisement
Table of Contents
