Applying Eq To The Input Channels Eq; Dynamics Processor; Muting Input Channels (On/Off); Setting Input Channel Levels - Yamaha 03D Owner's Manual
Digital mixing console
Hide thumbs
Also See for 03D:
- Application manual (89 pages) ,
- Technical note (7 pages) ,
- Technical notes (7 pages)
Table of Contents
Advertisement
42
Chapter 4—Input Channels
Applying EQ to the Input Channels EQ
Each input channel features four-band parametric EQ. See EQ on page 45 for more
information.
Dynamics Processor
Each input channel features a dynamics processor. See Dynamics Processors on page
143 for more information.
Muting Input Channels (ON/OFF)
ON
When the [SOLO] function is on, the [ON] buttons work as solo buttons, not mute
buttons.
When channels are configured as a stereo pair using the Pair function (Stereo Pairs on
page 114), the [ON] buttons of the two channels work together, and either button can
be used to switch the pair on and off.
Channels can also be grouped for multiple mute control using only one [ON] button.
See Mute Groups on page 113 for more information.
Setting Input Channel Levels
6
0
5
10
20
40
60
00
3. Use the faders to adjust the channel levels.
When channels are configured as a stereo pair using the Pair function (Stereo Pairs on
page 114), the faders of the two channels work together, and either fader can be used to
adjust the level of the stereo pair.
Pan, Balance & Routing
Input channel and stereo input channel signals can be routed to buses 1 to 4 and the
Stereo bus. Input channel signals can be panned. Stereo input channel signals can be
balanced and panned. Stereo input channel pan can be used to adjust the width of ste-
reo signals. Pan, balance, and routing settings are made on the Pan/Route pages. See
Stereo Pan, Balance & Routing on page 59 for more information.
03D—Owner's Manual
Channels can be muted using the [ON] buttons. These buttons contain an
indicator that lights up when a channel is on. The function of each [ON] but-
ton depends on the selected Mixing Layer. See ON Buttons on page 31 for more
information.
Input channel and stereo input channel levels are controlled using the faders.
The function of each fader depends on the selected fader mode and Mixing
Layer. See Faders on page 32 for more information. The selected fader mode
is shown on the display. See Display on page 24 for more information. The
stereo input channel fader is affected by the fader modes, but not the Mixing
Layer.
1.Press the [FADER] button.
The Meter page appears and the faders function as normal channel faders.
2.Use the [MIXING LAYER] button to select Mixing Layer 1–16
or 17–24/MASTER.
Advertisement
Table of Contents
