Programming Codes From Other Remote Controls (Learn) - Yamaha RX-V2500 Owner's Manual
Yamaha rx-v2500: owners manual
Hide thumbs
Also See for RX-V2500:
- Owner's manual (107 pages) ,
- Product catalog (44 pages) ,
- Service manual (119 pages)
Table of Contents
Advertisement
6
Press ENTER to set the number.
"OK" appears in the display window if setting was
successful.
"NG" appears in the display window if the setting
was unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button or SELECT k/n
to select the component, then repeat steps 4 through 6.
7
Press LEARN again to exit from the setup
mode.
LEARN
8
Press one of the buttons shaded below to
see if you can control your component. If you
can, the remote control code is correct.
TRANSMIT
SYSTEM
POWER
POWER
STANDBY
POWER
TV
AV
A
B
INPUT MODE
SLEEP
PHONO
TUNER
CD
MULTI CH IN
V-AUX
CBL/SAT
MD/TAPE
CD-R
DTV
VCR 1
DVR/VCR2
DVD
y
If the manufacturer of your component has more than one
code, try each of them until you find the correct one.
Notes
• "ERROR" appears in the display window if you press a button
not indicated in the respective step, or when you press more
than one button simultaneously.
• The supplied remote control does not contain all possible codes
for commercially available audio and video components
(including YAMAHA components). If operation is not possible
with any of the remote control codes, program the new remote
control function using the Learn feature (see "Programming
codes from other remote controls (Learn)") or use the remote
control supplied with the component.
• Function programmed using the learn feature take priority over
remote control code functions.
FREQ/RDS
EON
MODE PTY SEEK START
REC
DISC SKIP
OFF
ON
MACRO
LEARN
CLEAR
RE–NAME
Programming codes from other
remote controls (Learn)
Use the Learn feature if you want to program functions
not included in the basic operations covered by remote
control codes, or an appropriate remote control code is not
available. You can program any of the buttons available in
the component control area (see page 66). The buttons can
be programmed independently for each component.
Note
This remote control transmits infrared beams. If the other remote
control also uses infrared beams, this remote control can learn
most of its functions. However, you may not be able to program
some special signals or extremely long transmissions. (Refer to
the operating instructions for the other remote control.)
1
Set AMP/SOURCE/TV to SOURCE.
AMP
SOURCE
TV
2
Press an input selector button to select a
source component.
A
B
INPUT MODE
SLEEP
PHONO
TUNER
CD
MULTI CH IN
V-AUX
CBL/SAT
MD/TAPE
CD-R
DTV
VCR 1
DVR/VCR2
DVD
3
Place this remote control about 5 to 10 cm
(2 to 4 in) apart from the other remote control
on a flat surface so that their infrared
transmitters are aimed at each other.
5 to 10 cm (2 to 4 in)
REMOTE CONTROL FEATURES
69
- Quick Links:
- Rear Panel
- Speaker Connections
Hide quick links:
Advertisement
Table of Contents
