Yamaha MX-830 Owner's Manual page 8

Natural sound power amplifier

Hide thumbs Also See for MX-830:

Heavy-gauge speaker cords

First, unscrew and remove the plastic wire holders. Insert the stripped

ends of the speaker cords into the holders until they protrude from the

other side.

Splay the strands as shown; then screw the wire holders back on.

Note:

When

inserting the stripped ends of the speaker cords as shown above,

make sure that at least 1/16 inch (1.6 mm) of insulation is inside the wire

holders (ie. no exposed wire is visible) and that no loose conductor wire

strands are protruding after the connection is made. To prevent speaker

wires from loosening, make sure that the wire holders are firmly screwed

in.

Banana plug connectors (except U.K. and Europe models)

Banana Plug connections are also possible. Simply insert the Banana P

connector into the corresponding terminal.

ΜΧ-650

1. Strip off about 10 mm

(3/8 in.) of the insulation (leaving only the cor

wire) from the end of each speaker connection wire to be connected

to this unit.

. Unscrew the knob (for the SPEAKER

connection terminal to which the

speaker connection wire is to be connected) until the wire can be

inserted into the hole at the top of the rear part of the knob. Each

speaker connection wire should be inserted securely, taking care that

does not contact any other terminal. Then turn the knob to tighten tr

knob securely.

Red: positive (+)

Black: negative (+)

The speaker connection wires should |

no longer than necessary.

Table of Contents

Mx-630