Table of Contents
Advertisement
Installation
Unpacking
After removing outer carton,
reinforcing angles and polythene
wrapping, proceed as follows:
undo the two winged screws A and B
on the back of the washing machine
(fig. 1);
remove the two rods fastened by the
winged screws A and B (fig. 2);
tilt the machine and remove
polystyrene base packing;
remove the four cardboard spacers
which will have fallen to the bottom of
the machine during the preceding
operation.
Positioning & Levelling
Move the washer to its permanent
operating location and carefully level
it by adjusting the feet and locking
them in position with the lock nut
(fig. 3).
It is recommended to perform this
work very accurately to avoid any
vibration, noise or shifting of the
appliance during operation.
Also make sure that the washing
machine does not touch walls,
furniture, etc. while working.
3
Advertisement
Table of Contents
