Table of Contents
Advertisement
abrasives which may mar the paint or protec-
tive finish. When finished cleaning, start the
engine and let it idle for several minutes.
9. If the headlight lens has fogged up, start the
engine and turn on the headlight to help re-
move the moisture.
EBU27264
Storage
Short-term
Always store your ATV in a cool, dry place and, if
necessary, protect it against dust with a porous
cover. NOTICE: Storing the ATV in a poorly ven-
tilated room or covering it with a tarp while it is
still wet, will allow water and humidity to seep
in and cause rust. To prevent corrosion, avoid
damp cellars, stables (because of the presence
of ammonia) and areas where strong chemi-
cals are stored.
[ECB00722]
Long-term
Before storing your ATV for several months:
1. Make any necessary repairs and perform all
outstanding maintenance.
2. Follow all the instructions in the Cleaning sec-
tion of this chapter.
3. Fill up the fuel tank and add fuel stabilizer (Fu-
el Med Rx if available), and then run the en-
gine for 5 minutes to distribute the treated
fuel.
Specified amount:
7.5 ml per liter of fuel (1 oz per gallon)
4. Perform the following steps to protect the en-
gine from internal corrosion.
a. Remove the spark plug cap and spark
plug.
b. Pour a teaspoonful of engine oil into the
spark plug bore.
c. Install the spark plug cap onto the spark
plug, and then place the spark plug on the
cylinder head so that the electrodes are
grounded. (This will limit sparking during
the next step.)
d. Turn the engine over several times with
the starter. (This will coat the cylinder wall
with oil.)
e. Remove the spark plug cap from the spark
plug, and then install the spark plug and
the spark plug cap.
5. Lubricate all control cables and the pivoting
points of all levers and pedals.
10-2
10
- Quick Links:
- Speed Limiter
- Engine Oil
- Engine Oil
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
