Advertisement
Ensure that the nozzle is aimed correctly at the working surface before switching on the machine.
"
Before operating the trigger, Grip the gun firmly to counteract the recoil from the high pressure water jet.
"
WARNING! Avoid sudden bursts of water as these will cause water pressure to drop and put extreme pressure on hoses and connectors.
F
If, during operation, power failure occurs turn the electricity and water off for safety reasons (see Note ‘d’ at end of Section 4).
"
WARNING! The high pressure jet will cause loose particles to be propelled at high speed, which may cause serious injury.
F
WARNING! DO NOT use the machine without a water supply. Dry running can seriously damage the unit.
F
WARNING! Model PC2100 - DO NOT leave motor running for more than 1-2 minutes without operating the trigger, as
F
temperature/pressure increases may damage the sealing system. Note: PC2100PLUS may be left switched on for up to 15 minutes
without operating the trigger.
WARNING! Model PC2100PLUS - DO NOT leave the washer switched on for more than 15 minutes without operating the trigger.
F
DO NOT obstruct ventilation grills during operation.
&
DO NOT stand the washer on end during use. The washer must only be used when horizontal.
&
DO NOT use the washer with flammable or toxic liquids or any other product. Only use recommended
&
detergent. Unapproved detergents may corrode the machine cover and accessories.
DO NOT jam the trigger in the operating position.
&
DO NOT adjust any internal control valves, as these have been set at the factory.
&
DO NOT leave the washer running unattended.
&
DO NOT connect other appliances to the machine inlet or outlet.
&
DO NOT use in damp or wet weather conditions.
&
DO NOT move the unit by pulling the hoses or electrical cables. Use handle (or trolley on PC2100PLUS).
&
DO NOT touch plug with wet hands. To minimize the risk of electrocution keep all connections dry and off the ground.
&
DO NOT direct the water jet against yourself, other persons or animals, electrical equipment or the machine itself.
&
DO NOT use the washer if you are tired or under the influence of alcohol, drugs or intoxicating medication.
&
DO NOT allow children or untrained persons to operate the washer.
&
WARNING! Discharge residual pressure before disconnecting the washer hose. Pressure left in unit may cause injury.
F
After use disconnect washer from electrical mains and water supply and store in a safe, dry, childproof area.
"
2. SPECIFICATION & CONTENT
2.1. SPECIFICATION
Lance . . . . . . . . . . . . . . . .Rotating Nozzle
Manifold Pressure . . . . . . . . . . . . .1420psi
Effective Cleaning Power . . . . . . . .2100psi
Water Flow . . . . . . . . . . . . . . . . . . .400l/h
Motor Power . . . . . . . . . . . . . . . . . .1300W
2.2.
CONTENTS
Unpack the product and check contents against the list below. Also check that the machine has an identification plate or label. If label or parts
are damaged or missing contact your supplier immediately.
PC2100 & PC2100PLUS
1 Water outlet
2 Water inlet with filter
3 Rotary lance
4 Gun with safety catch
5 Instruction manual
6 Power cord with plug
7 High pressure hose (attached to gun)
8 Nozzle cleaning tool
9 Motor ON/OFF switch
10 Detergent bottle with flow control
3. SET-UP
F
WARNING! Ensure pressure washer is switched off and unplugged from the mains electrical power supply before proceeding.
3.1.
To connect lance (fig. 1 item 3) or brush to the gun (4) push into the end of the gun and twist to lock, as in fig. 2.
3.2.
Connect the other end of high pressure hose to the water outlet (1) on the washer (fig 3).
3.3.
Connect the mains water supply hose (not supplied) to the water inlet (2) on the pressure washer (fig. 4). DO NOT turn the water on at this
stage. The supply hose must be reinforced, and have an internal diameter of 1/2”. The water supply must be at least equal to the
washer capacity. The water temperature must NOT exceed 122
F
WARNING! REMINDER: The pressure washer must only be used with clean water. Unfiltered water or corrosive chemicals must not
be used as these will damage the washer.
3.4.
Check the power ON/OFF switch and ensure that it is in the ‘OFF’ position.
3.5.
Having carefully followed the safety instructions in Section 1, plug the washer into the mains power supply. The washer is now ready
for use as described in Section 4.
Input Voltage. . . . . . . . . . . . . . . . . . . 230V
Motor Speed . . . . . . . . . . . . . . . . 2800rpm
Max. Inlet Temp . . . . . . . . . . . . . . . . . 50
Hose Length . . . . . . . . . . . . . . . . . . . 4.0m
Weight . . . . . . . . . . . . . . . . . . . . . . . 11kg
PC2100PLUS Only
Trolley (not shown)
Brush (not shown)
fig. 2
fig. 1
F (50
C). The water supply pressure must NOT exceed 145psi (10 bar).
O
O
fig. 3
By rotating the stream of water at
high speed, it is possible to increase
the effective cleaning pressure of
C
washer. We quote the pressure the
O
water leaves the pump at as ‘Manifold
Pressure’ and express cleaning
power of washer as the ‘Effective
Cleaning Power’.
fig. 4
PC2100.V2 & PC2100PLUS - 1 - 180203
Advertisement
