Table of Contents
Advertisement
Replace Chassis Components
• Prepare an antistatic surface or packing materials for each module that you remove from the chassis.
Procedure
Step 1
If you are replacing a fabric module, open the packaging for the new module and inspect it for damage.
If the module is damaged, alert the Technical Assistance Center (TAC) and stop this replacement process
until you have an undamaged module to install.
Step 2
Run the no poweroff module (x)location command.
a) Verify that the fabric LED for the slot that you specified turns off. Also, you can use the show platform
command to verify that the status of the module is SHUT DOWN.
Since the Fan trays are blocking the view, fabric module LEDs might not be visible. Therefore, you can
verify the fabric module LEDs status using show led location 0/FClocation command.
Step 3
Remove the fan tray covering the fabric module in the chassis.
Refer the fan tray removal
Step 4
Remove the fabric module that you are replacing by following these steps:
a) Unscrew the two captive screws on the center of each of the two handles on the fabric module (see Callout
1 in the following figure).
b) Rotate the handles outwards until they stop (see Callout 2 in the following figure).
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of
the slot (see the following figure).
procedure:Replace a Fan Tray, on page 85
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
Remove a Fabric Module
89
Advertisement
Table of Contents
