Reversible Main Oven Door - Zanussi SC9412 Instructions For The Use & Care
Hide thumbs
Also See for SC9412:
- Instructions for the use and care (24 pages) ,
- Use & care manual (24 pages)
Table of Contents
Advertisement
Reversible Main Oven Door
On some models the main oven door of the cooker can be changed from left to right hand
hinging, if required.
This is a reasonably simple operation if carried out in accordance with these instructions.
1 pozi-drive screwdriver and 1 small adjustable spanner are needed.
(i)
Open door wide and support whilst removing the two screws from the top L.H. hinge
bracket. Remove hinge bracket and place to one side. Having done so, the door can now
be lifted off the bottom hinge pin (A).
(ii)
Remove the eight screws that secure the inner door panel to the outer door panel, and
remove the inner panel being careful not to disturb the insulation material (B).
(iii)
The inner door panel can now be turned through 180°. The door latch roller assembly
will then be on the opposite end of the door (L.H.). Replace and secure inner door panel to
outer door panel (C).
(iv)
Remove button plugs and hinge bushes (top and bottom) and transfer positions (D).
(v) The upper L.H. hinge bracket (already removed) should now be transfered to the R.H.
lower position (E).
(vi)
Remove the door catch striker and plate from R.H. side of chassis (F).
Remove blanking screw from L.H. side of chassis (H).
Replace blanking screws to R.H. side of chassis.
Refit door catch and plate into opposite L.H. position (Do not tighten at this stage).
(vii)
The door can now be located onto the R.H. bottom hinge and held in place while the
R.H. top hinge is fitted to the door and then secured to the chassis.
(The R.H. top hinge is the same hinge removed from the bottom L.H.) (G).
(viii)
Final adjustment: With the door still closed the door catch adjustment is automatic
and can now be tightened from the side.
Open inner glass door to 90°and remove by lifting up and
out. Release the top hinge from the inside of the oven by
removing the two fixing screws. Remove hinge pin by
loosening the fixing screws, and replace into opposite end
of hinge, re-tightening the screw. Remove blanking screws
from holes in right hand side of oven, and using these holes
4
Advertisement
Table of Contents
