Table of Contents
Advertisement
Fan Modules
3
4
The following table describes the LEDs for the 48-Port 10-Gbps Fiber Channel over Ethernet Module.
Table 13: Cisco MDS 9700 Series 48-Port 10-Gbps FCoE Module LEDs
LED
Status
ID
Link
Fan Modules
This section describes the fan modules present in the Cisco MDS 9700 Series Directors.
Cisco MDS 9700 Series Switches Hardware Installation Guide
52
Ejector Lever
Status LED
Status
Description
Green
All diagnostics pass. The module is operational (normal initialization
sequence).
Orange
One of the following occurs or occurred:
• The module is booting or running diagnostics (normal initialization
sequence).
• The inlet air temperature of the system has exceeded the maximum
system operating temperature limit (a minor environmental
warning). To ensure maximum product life, you should immediately
correct the environmental temperature and restore the system to
normal operation.
Red
One of the following occurs:
• The diagnostic test failed. The module is not operational because
a fault occurred during the initialization sequence.
• The inlet air temperature of the system has exceeded the safe
operating temperature limits of the card (a major environmental
warning). The card has been shut down to prevent permanent
damage.
The operator has activated this LED to identify this module in the chassis.
Blinking blue
Off
This module is not being identified.
Solid green
Link is up.
Intermittent
Link is up (traffic on port).
blinking green
Solid orange
SFP is not present or Admin is down.
Blinking orange
A fault condition exists.
Off
The port is not active or the link is not connected.
7
Link LEDs
8
FCoE port group. Each port group
consists of 4 ports.
Product Overview
Advertisement
Table of Contents
Troubleshooting
