Connect A Wireless Client To Your Router; Wps Button - D-Link Go-RT-N300 User Manual

N300 wi-fi router

Hide thumbs Also See for Go-RT-N300:

Table of Contents

Section 4 - Security

Connect a Wireless Client to your Router

The easiest and most secure way to connect your wireless devices to the router is WPS (Wi-Fi Protected Setup). Most wireless

devices such as wireless adapters, media players, Blu-ray DVD players, wireless printers and cameras will have a WPS button (or

a software utility with WPS) that you can press to connect to the Go-RT-N300 router. Please refer to your user manual for the

wireless device you want to connect to make sure you understand how to enable WPS. Once you know, follow the steps below:

Step 1 - Press the WPS button (located on the side) on the router for a few seconds until the WPS button starts blinking.

Step 2 - Within 2 minutes, press the WPS button on your wireless client (or launch the software utility and start the WPS process).

Step 3 - Allow up to 1 minute to configure. Once the WPS light stops blinking, you will be connected and your wireless connection

will be secure with WPA2.

D-Link GO-RT-N300 User Manual

Table of Contents