TIP
• Perform the thickness measurement without
applying the oil.
• This step should be performed only if the fric-
tion plates and clutch plates were replaced.
• To measure the total width of the friction plates
and clutch plates, combine 9 friction plates and
8 clutch plates as shown.
a
a. Assembly width adjusted by clutch plate 2
"1" and "2".
b. Select the clutch plate 2 from the following
table.
Clutch plate 2 "1"
BR9-16324-00
1.6 mm (0.063 in)
5VY-16325-00
2.0 mm (0.079 in)
4B1-16325-00
2.3 mm (0.091 in)
Clutch plate 2 "2"
BR9-16324-00
1.6 mm (0.063 in)
5VY-16325-00
2.0 mm (0.079 in)
4B1-16325-00
2.3 mm (0.091 in)
TIP
When adjusting the clutch assembly width [by
replacing the clutch plate(s)], be sure to replace
the clutch plate 2 "1" first.
After replacing the clutch plate 2 "1", if specifica-
tions cannot be met, replace the clutch plate 2
"2".
EAS30351
CHECKING THE CLUTCH SPRINGS
The following procedure applies to all of the
clutch springs.
a
1. Check:
• Clutch spring
Damage → Replace the clutch springs as a
set.
2. Measure:
• Clutch spring free length
Out of specification → Replace the clutch
springs as a set.
STD
EAS30352
CHECKING THE CLUTCH HOUSING
1. Check:
• Clutch housing dogs
Damage/pitting/wear → Deburr the clutch
housing dogs or replace the clutch housing.
TIP
STD
Pitting on the clutch housing dogs will cause er-
ratic clutch operation.
G088994
5-52
2
Clutch spring free length limit
42.53 mm (1.67 in)
CLUTCH
1