Table of Contents
Advertisement
5.3
Mounting and installed the machine
5.3.1
Preparing the assembly area
1. Prepare a suitable assembly area (e.g. assembly stands). Make sure that the assembly area
has sufficient clearance from the floor for the DE shaft end. The necessary data is provided
in the machine dimension drawing.
2. Refer to the shipping documents to check that all motor components are available for
assembly.
5.3.2
Lift the machine to where it will be mounted and position it
• For vertical installation, use all the eyebolts provided and when necessary, hoisting straps
according to EN 1492-1 and/or lashing straps according to EN 12195-2 to stabilize the
position.
• Prevent foreign bodies from falling into the fan cover. For vertical machine installation
with the shaft end facing downwards, attach a protective canopy.
• If the shaft extension is facing upwards, the user must prevent liquid from moving along
the shaft and entering the motor.
• Clean bare metal surfaces with anti-corrosion agent using mineral spirits to ensure proper
installation and/or machine mounting.
• Do not obstruct the ventilation. Do not draw in the hot discharged air directly – also from
adjacent equipment.
• Avoid exposing them to direct, intense solar radiation, rain, snow, ice, or also dust for
extended periods. Attach a covering structure or an additional cover when using or storing
outdoors.
• Do not exceed the permissible axial and radial forces.
• When clouds or layers of dust are present, strictly maintain the temperature limits
according to EN/IEC 60079-14. The maximum surface temperature is stamped on the
rating plate for dust explosion-proof motors.
• Only use explosion-proof machines in the appropriate areas in accordance with
directive 1999/92/EC or in accordance with the appropriate country regulations.
If the certification is supplemented by an X, comply with the special conditions in the EC
type examination certificate or the IECEx Certificate of Conformity. Certificate with special
conditions (Page 24)
• When installing electrical systems in hazardous zones, comply with EN/IEC 60079-14 and
the corresponding country regulations.
• Take into account thermal transfer between the driven load and the machine. Carefully
ensure that permissible temperatures are maintained.
1MB1.33 Eagle Line shaft heights 71 ... 315
Operating Instructions, 08/2023, A5E52990459A
5.3 Mounting and installed the machine
Assembly
71
Advertisement
Table of Contents
