Cisco Firepower 1010 Getting Started Manual page 134
Hide thumbs
Also See for Firepower 1010:
- Getting started manual (190 pages) ,
- Hardware installation manual (50 pages) ,
- Getting started (42 pages)
Table of Contents
Advertisement
Branch Office Installation
Step 9
Shut down the FTD so you can send the device to the remote branch office.
It's important that you shut down your system properly. Simply unplugging the power or pressing the power
switch can cause serious file system damage. Remember that there are many processes running in the
background all the time, and unplugging or shutting off the power does not allow the graceful shutdown of
your Firepower system.
a) Enter the shutdown command.
b) Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
c) After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
Branch Office Installation
After you receive the FTD from central headquarters, you only need to cable and power on the device so that
it has internet access from the outside interface. The central administrator can then complete the configuration.
Cable the Device
The FMC and your management computer reside at a remote headquarters, and can reach the FTD over the
internet. To cable the Firepower 1010, see the following steps.
Figure 43: Cabling a Remote Management Deployment
Cisco Firepower 1010 Getting Started Guide
132
All manuals and user guides at all-guides.com
Firepower Threat Defense Deployment with a Remote FMC
Advertisement
Chapters
Table of Contents
