Table of Contents
Advertisement
Steps
1. Remove the two (M1.4X1.2) screws that secure the SD card reader daughterboard FPC in place.
2. Disconnect and remove the SD card reader daughterboard FFC cable from the connector on the system board.
Installing the SD card reader daughterboard FPC
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION:
The information in this installation section is intended for authorized service technicians only.
The following image indicates the location of the SD card reader daughterboard FPC and provides a visual representation of the
installation procedure.
Removing and installing Field Replaceable Units (FRUs)
105
Advertisement
Table of Contents
