Cisco MDS 9000 Series Installing page 13

Hide thumbs Also See for MDS 9000 Series:

Table of Contents

Installing the Cisco MDS 9148T Switch

Figure 6: Installing Rack-Mount Brackets on the Front Side of the Chassis

Step 2

If you are installing the chassis into an ungrounded rack, you must attach a customer-supplied grounding wire to the

chassis. However, if you are installing the chassis into a grounded rack, you can skip this step.

Step 3

Install the switch onto the 2-post rack:

a. Holding the switch with both hands, position the back of the switch between the two posts of the rack. Then gently

move the switch until the rack-mount brackets come in contact with two rack posts.

b. Holding the chassis level, insert three screws (12-24 or 10-32, depending on the rack type) into each of the two

rack-mount brackets (using a total of six screws) and into the cage nuts or threaded holes in the rack or cabinet posts.

Installing the Switch into a 2-Post Rack

Installing the Cisco MDS 9148T Switch

Table of Contents

Mds 9148t