Table of Contents
Advertisement
User's Manual
❑
Create or invalidate a supervisor password token
NOTE: This function in the Supervisor password utility lets you
invalidate only supervisor tokens or all tokens, including user and
supervisor tokens.
❑
Specify restrictions for general users.
Starting the computer by password
If you registered a password, there are two ways to start the computer:
❑
Insert a password token before you turn on the computer. The computer will
start normally, without displaying a password prompt.
❑
Enter the password manually.
NOTE: The password is necessary only if the computer was shut down in
boot mode. It is not needed in Hibernation or Standby mode.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3,
message will appear in the LCD:
Password=
2. Enter the Password.
3. Press Enter.
NOTE: If you enter the password incorrectly three times in a row, the
computer shuts off. In this case, you must turn the computer back on to
retry password entry.
Power-up modes
The computer has the following power-up modes:
❑
Boot: Computer shuts down without saving data. Always save your work
before you turn the computer off in boot mode.
❑
Hibernation: Data in memory is saved to the hard disk.
❑
Standby: Data is maintained in the computer's main memory.
NOTE: Refer also to the sections
the power
in Chapter 3, Getting Started.
6-18
Turning on the power
Get other manuals https://www.bkmanuals.com
Getting
Started. The following
and
Turning off
Advertisement
Table of Contents
